停机检测和报警
停机状态是指将执行器位晋强制至预先确定的已知位置，而与所需位置无关。REC670可以编程为在停机时进入三种预定状态之一检测到条件，关闭条件可以配置为关闭电源
(禁用执行器的当前驱动器只)，转到最小(0%)位置，或转到最大(100%)位置，当停机条件不再存在时，驾驶员自动返回到非关闭状态并道循位置需求输入命令。关闭条件不需要“重置”命令
工作电压:100V-240VAC
工作频率:50/60HZ
最大功耗:10VA
工作温度:-40℃C至+70%C
防护等级:IP40
Stop detection and alarm
The hutdown state means that the actuator position is forced to a predetermined known position, regardless of the desired position. The REC670 can be programmed to enter one of three predetermined states upon shutdown when a condition is detected, and the shutdown condition can be configured to turn off the power
(Disable the current drive of the actuator only), turn to the minimum (0%) position, or turn to the maximum (100%) position, when the shutdown condition no longer exists, the driver automatically returns to the non-off state and follows the position requirement to enter the command. The shutdown condition does not require a "reset" command
Working voltage :100V-240VAC
Operating frequency :50/60HZ
Maximum power consumption :10VA
Operating temperature :-40℃C to +70%C
Protection class :IP40
| ABB | REC670 1MRK002814-AB |
| ABB | REC670 1MRK002814-AC |
| ABB | REF615C_E HCFFAEAGANB2BAA11E |
| ABB | REB670 1MRK002820-AC |
| ABB | RET670 1MRK002816-AB |
| ABB | REF545KC133AAAA |
| ABB | RER103 |
| ABB | G2010 A 10.4ST |
| ABB | PFSA103D 3BSE002492R0001 |
